www.express-builder.com

I got one of those $200 3D printers off Amazon. I've been using it to "print" parts so I can check for fit. This works well for small parts you might be having to build or machine or get machined. In the past I would use insulating foam panels from the big box stores. This is kind of OK fo...

https://www.pegasusautoracing.com

They have a pretty good selection and competitive prices. Reasonable cost on shipping.

Not affiliated in any way. Needed some AN7 bolts and they were 1/2 price of Aircraft Spruce on the size I needed.

I'm not sure you will find much on the RG. There are some example POH, WB and such in the documents section. You will need to adjust based on your actual W&B. There may also be a condition inspection list example there. I have not looked in a long time. As far as strut service docs you may be ab...

I use acetone. Works for duct tape and masking tape. I use a razor blade to remove most of it first then finish up with acetone.

I just looked at one of the manuals from http://www.arcticaircooler.com The manual says you can program a "de-ice" time but the factory default is "off". It probably just shuts the compressor off for some amount of time. Some home hvac units will switch the refrigerant flow so th...

I dont have any AC plans (yet). I put the vent in to help cabin air flow. Have you tried to contact Artic Air? They may be able to help. If the evaporator coil is freezing up it could be low refrigerant (not likely in that unit) or not enough air flowing over it. The evaporator needs to absorb heat ...

How big is the exhaust port? I found some round 3 inch louvered vents. I think I got mine from a big box hardware store. Look around where they have dryer vents or hvac supplies. You can search for "marine engine bay vents". I mounted mine in the floor behind the big aft bulkhead. The rule...

Is this a solid plug or is it like a SAF-AIR drain valve? If it's a drain valve it's probably just a o-ring issue. I think you can get a re-build kit for them or you might have to replace it. I'm not sure what size it might be. If the leak is around a solid plug you might try some fuel lube on the p...

If you need the fiberglass hard points for seat belts, etc you can get sheets of that from eplastics.com
G10 FR4 sheets. You may have to search around the site to find them.

Who ever built it may have put the solid link in place. I dont like it. If the nose drops down the tire is only going to take up so much of the energy. The rest is going to try and flex the nose gear at the bracket. I have not done the math but some of the load will go to the firewall. Your nose wei...