Corvette LS-1 through 9 engines

Discussion of engine and propeller choices
skypuppy
Posts: 14
Joined: Sun Dec 07, 2014 12:50 am

Corvette LS-1 through 9 engines

Postby skypuppy » Fri Dec 26, 2014 7:24 pm

Has anyone installed one of these enginee? Do you actually have it flying? I'd like to know all about it! :)

Thanks.

LarryK
Posts: 19
Joined: Wed Dec 31, 2014 11:09 pm

Re: Corvette LS-1 through 9 engines

Postby LarryK » Thu Jan 01, 2015 10:29 pm

I picked up one with a LS1 but it's not ready to fly, I picked the plane because it wasn't a typical aircraft motor, what will have to be proven beneficial or detrimental.. a few months should have the answer on that.

kevin
Site Admin
Posts: 88
Joined: Tue May 20, 2014 6:46 pm
Location: KCRG
Contact:

Re: Corvette LS-1 through 9 engines

Postby kevin » Thu Jan 08, 2015 1:28 pm

There are a few LS1 engines flying. The early wheelers had 2 crashes due to this type of engine- not the engine per se, but the in flight fires were caused by the engine. In both cases an oil line leaked oil onto the headers and caused a fire. Both times it was a rubber hose that ruptured.

If you dont listen to anything else that I tell you listen to this: Run hard pipe everywhere possible especially oil and fuel lines. Cover all the lines,even SS braided, with the orange fire flex cover. In the event of a leak the fluid is contained and can be directed outside of the cowling.
Pay close attention to the routing of all fluid lines, keep them away from everything and tie them down. Always think about the fluid and where it will go.

I am an A&P and work on lots of certified planes. The biggest difference in construction is that experimental builders want to rubber hose everything, certified planes have very little flex hose. Most Continental oil coolers are bolted straight to the block, no hoses at all.

My second Wheeler is powered by a 300 HP Mozda rotary engine 13b with P ports and a turbo. And almost no rubber hoses. Short sections where needed, none where not needed.

Johnwell
Posts: 13
Joined: Sun Jul 17, 2016 6:00 pm
Location: Danville, IL

Re: Corvette LS-1 through 9 engines

Postby Johnwell » Thu Aug 11, 2016 8:01 pm

Hi Larry,
I'm seriously curious how your LS1 is doing! Any news?

John

skypuppy
Posts: 14
Joined: Sun Dec 07, 2014 12:50 am

Re: Corvette LS-1 through 9 engines

Postby skypuppy » Thu Nov 02, 2017 2:50 pm

I'm very curious, too.


Return to “Engine/ Prop choices”

Who is online

Users browsing this forum: No registered users and 1 guest